I’m making the doors for my house. Because I’m crazy.
| Task | Status | Time estimate (minutes) | Actual time (minutes) |
|---|---|---|---|
| Mill stiles one side | Done | 30 | 30 |
| Glue up stiles | Done | 30 | 60 |
| Mill stiles to final thickness | Done | 30 | 120 |
| Mill rails and center circle to 1 3/8 | Done | 30 | 60 |
| Cut rails and stiles to rough thickness | Done | 60 | 45 |
| Glue up top arch pieces | Done | 30 | 30 |
| Cut top arch profile | Done | 30 | 30 |
| Cut top arch ogee | Done | 30 | 30 |
| Cut top arch to final thickness | Done | 30 | 20 |
| Cut center arch profiles | Done | 30 | 45 |
| Cut 12 mortises | Done | 180 | 240 |
| Cut ogee outside profiles | Done | 30 | 30 |
| Cut ogee inside profiles | Done | 30 | 120 |
| Mill up a bunch of 1 1/4 stock | Done | 60 | 90 |
| Glue up top panel | Done | 30 | 30 |
| Glue up bottom panel | Done | 30 | 30 |
| Make loose tenons | Done | 30 | 30 |
| Cut top panel to square dimensions | Done | 30 | 30 |
| Cut bottom panel to square dimensions | Done | 30 | 30 |
| Cut top panel top arch shape | Done | 30 | 30 |
| Cut top panel bottom arch shape | Done | 30 | 30 |
| Cut bottom panel top arch shape | Done | 30 | 30 |
| Cut bottom panel bottom arch shape | Done | 30 | 30 |
| Cut top panel raised profile | Done | 30 | 90 |
| Cut bottom panel raised profile | Done | 30 | 90 |
| Dry fit | Done | 30 | 120 |
| Initial sanding | Done | 60 | 60 |
| Glue up | Done | 30 | 60 |
| Cut door to final dims | Done | 30 | 60 |
| Final Sanding | Done | 60 | 240 |
| Prime in grey | Done | 30 | 60 |
| Sand smooth | Done | 30 | 60 |
| Coat 1 spray | Done | 30 | 60 |
| Coat 2 spray | Done | 30 | 60 |
| Total | 1290 | 2180 | |
| Total (hours) | 21.5 | 36.333333333333 |
No domino, but I have a mortiser. This actually worked surprisingly well once I found a janky way to keep the clamps in place when they were loose. Then it was just slide board to the mark, tighten clamps, cut mortise, repeat.